Rear turn brake light out diagnostic having your turn signal stuck on is not only annoying it can also be confusing and dangerous to drivers behind you.
Audi a6 rear brake light fault.
But im thinking is it because i just changed my trunk light to a can bus led.
I have an 08 audi a6 quattro 3 2 and now experiencing the left rear intermittent tail light issue.
My 2008 audi a6 was giving me bulb out errors and one of my running lights wasn t working properly.
Read on to learn about some of the more common reasons why this happens so that you can diagnose the problem.
Estimate does not include taxes and fees.
I went outside to see and my tailights were on and my reverse lights were on.
A customer came in saying that they had a message on the dash.
Interrogation of the fault memory revealed faults 2433 holding meter right voltage supply and 473 electronic parking hand brake control unit implausible signal.
By jeffrey bausch april 7 2016.
The bulbs themselves were fine and most of what i read.
So they both work.
Use a micrometer to measure the thickness of the brake disc.
Hello all i am new to this forum and thank in advance for any help.
I do have the led rear tail lights fyi.
2005 audi a6 abs brake esp lights 24 answers.
Labor costs are estimated between 99 and 125 while parts are priced between 231 and 252.
From the factory the rear brake disc on your a6 will be 14 mm thick.
Like this customer s 2006 audi a6 3 2 quattro you may have corrosion on the parking brake harness.
If the brake light in your a6 is stuck on in your dashboard you d be best served to address the issue sooner rather than later so that you don t wind up causing serious and expensive damage to your vehicle.
The average cost for an audi a6 quattro brake pad replacement is between 330 and 377.
I was in park and had my headlights on.
I changed the bulb and everything checked the fuse and wires everything was fine.
Audi a6 1997 2004 technical articles rear brake disc replacement.
I have tried all the youtube work arounds like.
So as i came out of the gym today my tail light and reverse light warning indicator came on.
If the thickness is adequate you can have the rotors turned on a lathe to remove glazing and grooves from the old.
Okay so few weeks ago my abs brake esp brake fault warning lights came on and the whole rear left lights went out.
The wear limit is 11 mm.
By jeffrey bausch april 8 2016.